Is it just me or do others have network issues with mythbuntu?
Anyways, I have a issue that is quite strange. I have Mythbuntu's latest release and a ceton pcie card with comcast Mcard installed. Has worked fine until I installed updates for mythbuntu. Then I had a hard drive die. Ok, Time to just reload this thing and start fresh. Well, For some reason my mythtv install can not communicate with the ceton card.
Now I noticed that when I went into the Information Center I could see the four tuners I setup but I see the following messages:
I pulled the card and reseated the Mcard from comcast and reinstalled the ceton card but still the same issue. Checking the logs for mythtv I can see that mythbackend cannot communicate with the ceton card.Tuner 1 has an error
Tuner 2 has an error
Tuner 3 has an error
Tuner 4 has an error
Here is some more info:
The ifconfig output seems correct for the card. I have it setup in my 'Interfaces' file in order to get mythbuntu to assign an ip address. Here is my 'Interfaces' file:ctn0 Link encap:Ethernet HWaddr 00:22:2c:ff:ff:ff
inet addr:192.168.200.1 Bcast:192.168.200.255 Mask:255.255.255.0
inet6 addr: fe80::222:2cff:feff:ffff/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:2033 errors:0 dropped:0 overruns:0 frame:0
TX packets:133 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:718583 (718.5 KB) TX bytes:23899 (23.8 KB)
Interrupt:46
Ok, So - I openned up chrome on the mythtv box and tried to get to 192.168.200.1 and got mythweb instead. So, I shutdown apache2 and tried again thinking it was somehow blocking it but then I cannot connect to anything.auto lo ctn0
iface lo inet loopback
allow-hotplug ctn0
iface ctn0 inet static
address 192.168.200.1
netmask 255.255.255.0
auto eth0
iface eth0 inet static
address 10.0.1.12
netmask 255.255.255.0
I did try a reset with the reset_network.py script from Ceton and it said "Unable to send".
Did my Ceton card just die?
Northpoint.